![]() ![]() Since Warp Stabilizer is an analysis effect, every change you make prompts a need to reanalyze. You can save Warp Stabilizer settings as a preset, but you need to click the Analyze button in the Effect Controls panel to launch it. But then don't forget to turn it off before rendering, since you want the effects in your final export. If you need to find all stabilized clips, there is a fast way to find them all, and I previously wrote a blog post about it here. Keep in mind that it only works well for footage that was intended to be locked in the first place. If you want the result of stabilization to look like the footage was shot on a tripod, you can accomplish this by changing the Mode to No Motion. Therefore, it would need to be analyzed again. Why does it matter? If you change anything in the settings of Lumetri and it is applied before Warp Stabilizer, the source for Warp Stabilizer analysis has changed. ![]() Warp Stabilizer should always be applied at the top. In Premiere Pro and in After Effects as welleffects on the top are applied first. ![]() If you choose Smooth Motion as a Mode for Warp Stabilizer, there are three main parameters to consider. For example, 4K footage has more data than p, so it will take longer to analyze. It takes some time, depending on the duration, frame rate, and resolution of the footage. Once you do this, the tool launches instantly and analyzes the footage. You apply Warp Stabilizer by dragging it onto a clip. First, check out my video breakdown below and then read on for additional, step-by-step tips that I hope you will find helpful. My tutorial begins with the basics and walks you through everything you need to know about this visual effect, ranging from how to use Warp Stabilizer presets to how to successfully implement the effect within a Proxy Workflow. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |